Visual Basic 6.0

SSH Tunnel Through an Outbound SOCKS Proxy

Demonstrates reaching the SSH server through an outbound SOCKS proxy using the SocksVersion, SocksHostname, SocksPort, SocksUsername, and SocksPassword properties.

Background: This is the reverse direction from dynamic forwarding: here a SOCKS proxy is used to reach the SSH server, for networks where outbound connections must pass through one. SocksVersion is the switch — 0 means no SOCKS, while 4 or 5 selects the protocol. SOCKS5 supports username/password authentication and remote DNS; SOCKS4 supports only a username.

Chilkat Visual Basic 6.0 Downloads

Download Chilkat for Visual Basic 6.0

Visual Basic 6.0

Dim success As Long
success = 0

'  Demonstrates reaching the SSH server through an outbound SOCKS proxy using the SshTunnel
'  properties SocksVersion, SocksHostname, SocksPort, SocksUsername, and SocksPassword.

Dim tunnel As New ChilkatSshTunnel

'  Set SocksVersion to 4 or 5 to route the outbound connection to the SSH server through a SOCKS
'  proxy.  A value of 0 (the default) means no SOCKS proxy.
tunnel.SocksVersion = 5
tunnel.SocksHostname = "socks.example.com"
tunnel.SocksPort = 1080

'  SOCKS4 supports only a username; SOCKS5 supports username and password.
tunnel.SocksUsername = "myProxyLogin"
tunnel.SocksPassword = "myProxyPassword"

tunnel.DestHostname = "db.internal.example.com"
tunnel.DestPort = 5432

'  Connect to the SSH server through the SOCKS proxy configured above.
Dim sshPort As Long
sshPort = 22
success = tunnel.Connect("ssh.example.com",sshPort)
If (success = 0) Then
    Debug.Print tunnel.LastErrorText
    Exit Sub
End If

'  Normally you would not hard-code the password in source.  You should instead obtain it
'  from an interactive prompt, environment variable, or a secrets vault.
Dim password As String
password = "mySshPassword"

success = tunnel.AuthenticatePw("mySshLogin",password)
If (success = 0) Then
    Debug.Print tunnel.LastErrorText
    Exit Sub
End If

Dim listenPort As Long
listenPort = 1080
success = tunnel.BeginAccepting(listenPort)
If (success = 0) Then
    Debug.Print tunnel.LastErrorText
    Exit Sub
End If

Debug.Print "Tunnel established through the SOCKS proxy."

Dim waitForThreadExit As Long
waitForThreadExit = 1
success = tunnel.CloseTunnel(waitForThreadExit)
If (success = 0) Then
    Debug.Print tunnel.LastErrorText
    Exit Sub
End If