Check Whether an SSH Exit Status Was Received

See more SSH Examples

Demonstrates the Chilkat Ssh.ChannelReceivedExitStatus method, which reports whether the server supplied an exit-status value for a channel. The only argument is the channel number. When it returns true, call GetChannelExitStatus to read the value.

integer li_rc
integer li_Success
oleobject loo_Ssh
integer li_SshPort
string ls_Password
integer li_ChannelNum
integer li_ExitStatus

li_Success = 0

//  Demonstrates the Ssh.ChannelReceivedExitStatus method, which reports whether the server
//  supplied an exit-status value for a channel.  The only argument is the channel number.  When
//  it returns 1, call GetChannelExitStatus to read the value.

loo_Ssh = create oleobject
li_rc = loo_Ssh.ConnectToNewObject("Chilkat.Ssh")
if li_rc < 0 then
    destroy loo_Ssh
    MessageBox("Error","Connecting to COM object failed")
    return
end if

li_SshPort = 22
li_Success = loo_Ssh.Connect("ssh.example.com",li_SshPort)
if li_Success = 0 then
    Write-Debug loo_Ssh.LastErrorText
    destroy loo_Ssh
    return
end if

//  Normally you would not hard-code the password in source.  You should instead obtain it
//  from an interactive prompt, environment variable, or a secrets vault.
ls_Password = "mySshPassword"

li_Success = loo_Ssh.AuthenticatePw("mySshLogin",ls_Password)
if li_Success = 0 then
    Write-Debug loo_Ssh.LastErrorText
    destroy loo_Ssh
    return
end if

li_ChannelNum = loo_Ssh.OpenSessionChannel()
if li_ChannelNum < 0 then
    Write-Debug loo_Ssh.LastErrorText
    destroy loo_Ssh
    return
end if

li_Success = loo_Ssh.SendReqExec(li_ChannelNum,"test -f /etc/hosts")
if li_Success = 0 then
    Write-Debug loo_Ssh.LastErrorText
    destroy loo_Ssh
    return
end if

//  IMPORTANT: Set a read timeout.  ReadTimeoutMs defaults to 0, which means no limit -- without
//  it, this call waits forever if the server never sends channel close.
loo_Ssh.ReadTimeoutMs = 15000

li_Success = loo_Ssh.ChannelReceiveToClose(li_ChannelNum)
if li_Success = 0 then
    Write-Debug loo_Ssh.LastErrorText
    destroy loo_Ssh
    return
end if

//  The server is not required to send an exit status for every channel type or command.
if loo_Ssh.ChannelReceivedExitStatus(li_ChannelNum) then
    li_ExitStatus = loo_Ssh.GetChannelExitStatus(li_ChannelNum)
    Write-Debug "Exit status: " + string(li_ExitStatus)
else
    Write-Debug "The server did not provide an exit status."
end if

loo_Ssh.Disconnect()


destroy loo_Ssh