PowerBuilder

Verify and Pin the FTPS Server Certificate

Demonstrates the certificate-verification properties RequireSslCertVerify, TlsPinSet, and the read-only SslServerCertVerified.

Background: By default a TLS connection is not rejected merely because certificate-chain verification fails, so RequireSslCertVerify = true is the important hardening step — it makes an expired, unsigned, or untrusted certificate abort the connection. TlsPinSet adds public-key pinning on top: the handshake fails unless the server's SPKI fingerprint matches one you configured, defending against a mis-issued certificate that would otherwise validate. Pinning supplements verification rather than replacing it. SslServerCertVerified reports the outcome.

Chilkat PowerBuilder Downloads

Download Chilkat for PowerBuilder

PowerBuilder

integer li_rc
integer li_Success
oleobject loo_Ftp

li_Success = 0

loo_Ftp = create oleobject
li_rc = loo_Ftp.ConnectToNewObject("Chilkat.Ftp2")
if li_rc < 0 then
    destroy loo_Ftp
    MessageBox("Error","Connecting to COM object failed")
    return
end if

loo_Ftp.Hostname = "ftp.example.com"
loo_Ftp.Username = "myFtpLogin"

loo_Ftp.AuthTls = 1

//  Normally you would not hard-code the password in source.  You should instead obtain it
//  from an interactive prompt, environment variable, or a secrets vault.
loo_Ftp.Password = "myPassword"

//  Reject the connection if the server certificate cannot be verified (expired, bad signature,
//  untrusted chain, etc.).  The default is 0, which does not reject on verification
//  failure -- set 1 for security.
loo_Ftp.RequireSslCertVerify = 1

//  Optionally pin the server's public key.  If none of the configured SPKI fingerprints matches,
//  the TLS handshake fails.  Pinning supplements normal verification; it does not replace it.
loo_Ftp.TlsPinSet = "sha256//YLh1dUR9y6Kja30RrAn7JKnbQG/uEtLMkBgFF2Fuihg="

li_Success = loo_Ftp.Connect()
if li_Success = 0 then
    Write-Debug loo_Ftp.LastErrorText
    destroy loo_Ftp
    return
end if

//  SslServerCertVerified reports whether the certificate chain was successfully verified.
if loo_Ftp.SslServerCertVerified then
    Write-Debug "The server certificate was verified."
end if

li_Success = loo_Ftp.Disconnect()
if li_Success = 0 then
    Write-Debug loo_Ftp.LastErrorText
    destroy loo_Ftp
    return
end if



destroy loo_Ftp