Lianja
Lianja
Verify and Pin the FTPS Server Certificate
See more FTP Examples
Demonstrates the certificate-verification properties RequireSslCertVerify, TlsPinSet, and the read-only SslServerCertVerified.
Background: By default a TLS connection is not rejected merely because certificate-chain verification fails, so
RequireSslCertVerify = true is the important hardening step — it makes an expired, unsigned, or untrusted certificate abort the connection. TlsPinSet adds public-key pinning on top: the handshake fails unless the server's SPKI fingerprint matches one you configured, defending against a mis-issued certificate that would otherwise validate. Pinning supplements verification rather than replacing it. SslServerCertVerified reports the outcome.Chilkat Lianja Downloads
llSuccess = .F.
loFtp = createobject("CkFtp2")
loFtp.Hostname = "ftp.example.com"
loFtp.Username = "myFtpLogin"
loFtp.AuthTls = .T.
// Normally you would not hard-code the password in source. You should instead obtain it
// from an interactive prompt, environment variable, or a secrets vault.
loFtp.Password = "myPassword"
// Reject the connection if the server certificate cannot be verified (expired, bad signature,
// untrusted chain, etc.). The default is .F., which does not reject on verification
// failure -- set .T. for security.
loFtp.RequireSslCertVerify = .T.
// Optionally pin the server's public key. If none of the configured SPKI fingerprints matches,
// the TLS handshake fails. Pinning supplements normal verification; it does not replace it.
loFtp.TlsPinSet = "sha256//YLh1dUR9y6Kja30RrAn7JKnbQG/uEtLMkBgFF2Fuihg="
llSuccess = loFtp.Connect()
if (llSuccess = .F.) then
? loFtp.LastErrorText
release loFtp
return
endif
// SslServerCertVerified reports whether the certificate chain was successfully verified.
if (loFtp.SslServerCertVerified) then
? "The server certificate was verified."
endif
llSuccess = loFtp.Disconnect()
if (llSuccess = .F.) then
? loFtp.LastErrorText
release loFtp
return
endif
release loFtp