AutoIt

Check Whether an SSH Exit Status Was Received

Demonstrates the Chilkat Ssh.ChannelReceivedExitStatus method, which reports whether the server supplied an exit-status value for a channel. The only argument is the channel number. When it returns true, call GetChannelExitStatus to read the value.

Background: Always test this before reading the exit status, because the server is not required to send one for every channel type or command — treating a missing status as "0" would silently turn a failure into a success. Exit status is independent of EOF and CLOSE: it can arrive after EOF and either before or together with CLOSE.

Chilkat AutoIt Downloads

Download Chilkat for AutoIt

AutoIt

Local $bSuccess = False

;  Demonstrates the Ssh.ChannelReceivedExitStatus method, which reports whether the server
;  supplied an exit-status value for a channel.  The only argument is the channel number.  When
;  it returns True, call GetChannelExitStatus to read the value.

$oSsh = ObjCreate("Chilkat.Ssh")

Local $iSshPort = 22
$bSuccess = $oSsh.Connect("ssh.example.com",$iSshPort)
If ($bSuccess = False) Then
    ConsoleWrite($oSsh.LastErrorText & @CRLF)
    Exit
EndIf

;  Normally you would not hard-code the password in source.  You should instead obtain it
;  from an interactive prompt, environment variable, or a secrets vault.
Local $sPassword = "mySshPassword"

$bSuccess = $oSsh.AuthenticatePw("mySshLogin",$sPassword)
If ($bSuccess = False) Then
    ConsoleWrite($oSsh.LastErrorText & @CRLF)
    Exit
EndIf

Local $iChannelNum = $oSsh.OpenSessionChannel()
If ($iChannelNum < 0) Then
    ConsoleWrite($oSsh.LastErrorText & @CRLF)
    Exit
EndIf

$bSuccess = $oSsh.SendReqExec($iChannelNum,"test -f /etc/hosts")
If ($bSuccess = False) Then
    ConsoleWrite($oSsh.LastErrorText & @CRLF)
    Exit
EndIf

;  IMPORTANT: Set a read timeout.  ReadTimeoutMs defaults to 0, which means no limit -- without
;  it, this call waits forever if the server never sends channel close.
$oSsh.ReadTimeoutMs = 15000

$bSuccess = $oSsh.ChannelReceiveToClose($iChannelNum)
If ($bSuccess = False) Then
    ConsoleWrite($oSsh.LastErrorText & @CRLF)
    Exit
EndIf

;  The server is not required to send an exit status for every channel type or command.
If ($oSsh.ChannelReceivedExitStatus($iChannelNum)) Then
Local $iExitStatus = $oSsh.GetChannelExitStatus($iChannelNum)
    ConsoleWrite("Exit status: " & $iExitStatus & @CRLF)
Else
    ConsoleWrite("The server did not provide an exit status." & @CRLF)
EndIf

$oSsh.Disconnect